EcoPure MW_MW30_450224 - Manual (Page 7)

7 Miracle Water Installation & Operation Manual
water softener removes the hardness minerals to eliminate these problems, and others.
Sodium Information: Water softeners using sodium chloride (salt) for regeneration and add
sodium to the water. Persons on sodium restricted diets should consider the added sodium as part
of their overall intake.
2. IRON in water is measured in parts per million (ppm). The total* ppm of iron, and type or types*,
is determined by chemical analysis. Four different types of iron in water are:
< Ferrous (clear water),
= Ferric (red water),
> Bacterial and organically bound iron,
? Colloidal and inorganically bound iron (ferrous or ferric).
*Water may contain one or more of the four types of iron and any combination of these. Total iron
is the sum of the contents.
< Ferrous (clear water) iron is soluble and dissolves in water. It is usually detected by taking a
sample of water in a clear bottle or glass. Immediately after taking, the sample is clear. As the water
sample stands, it gradually clouds and turns slightly yellow or brown as air oxidizes the iron. This
usually occurs in 15 to 30 minutes. This unit will remove moderate amounts of this type of iron (see
specifications).
When using the softener to remove Ferrous (clear water) iron, add 5 grains to the hardness setting
for every 1 ppm of Ferrous (clear water) iron.
= Ferric (red water), and > Bacterial and organically bound irons are insoluble. This iron is visible
immediately when drawn from a faucet because it has oxidized before reaching the home. It appears
as small cloudy yellow, orange, or reddish suspended particles. After the water stands for a period
of time, the particles settle to the bottom of the container. Generally these irons are removed from
water by filtration. Chlorination is also recommended for bacterial iron. This unit will not remove
ferric or bacterial iron.
? Colloidal and inorganically bound iron is of ferric or ferrous form that will not filter or exchange
out of water. In some instances, treatment may improve colloidal iron water, but always CONSULT
A QUALIFIED WATER CHEMISTRY LAB before attempting to treat it. Colloidal iron water
usually has a yellow appearance when drawn. After standing for several hours, the color persists and
the iron does not settle, but remains suspended in the water.
Iron in water causes stains on clothing and plumbing fixtures. It negatively affects the taste of food,
drinking water, and other beverages. This unit will not remove colloidal iron.
3. ACIDITY or acid water is caused by carbon dioxide, hydrogen sulfide, and sometimes industrial
wastes. It is corrosive to plumbing, plumbing fixtures, water heaters, and other water using
appliances. In can also damage and cause premature failure of seals, diaphragms, etc., in water
handling equipment.
A chemical analysis is needed to measure the degree of acidity in water. This is called the pH of
water. Water testing below 6.9 pH is acidic. The lower the pH reading, the greater the acidity. A
neutralizer filter or a chemical feed pump are usually recommended to treat acid water.
4. SEDIMENT is fine, foreign material particles suspended in water. This material is most often clay
or silt. Extreme amounts of sediment may give the water a cloudyappearance. A sediment filter
installed ahead of the water softener normally corrects this situation.