EcoPure MW_MW30_450224 - Manual (Page 18)

18 Miracle Water Installation & Operation Manual
Step 2. Set Water Hardness Number
1. Press the (Select/Menu) button once to display a flashing 25 and HARDNESS.
2. Press the UP or DOWN . buttons to set your water hardness number.
NOTE: Be sure to enter the grains per gallon (gpg) hardness of your water supply on page 4, for
future reference. If your water supply contains iron, compensate for it by adding to the
water hardness number. For example, assume your water is 20 gpg hard and contains 2 ppm
iron. Add 5 to the hardness number for each 1 ppm of iron. In this example, you would use 30 for
your hardness number.
20 gpg hardness
2 ppm iron x 5 = 10 +10
(times) 30 HARDNESS NUMBER
Step 3. Set Recharge (Regeneration) Time
1. Press the (Select/Menu) button once to display a flashing 2:00AM and RECHARGE TIME.
If no change is desired, go to Step 4. If you want to change the recharge start time, press the
UP
or DOWN . buttons until the desired starting time shows.
SELECT
MENU
SELECT
MENU