Autolock feature (if enabled), Deactivating/activating autolock feature, Locks and security – FORD 2011 Edge v.2 User Manual

Page 123

Advertising
background image

When you open one of the front doors and you lock the vehicle using the
driver or passenger power door lock control (with the vehicle not in P
(Park) and the ignition off, or the ignition on), all doors will lock, then
all doors will automatically unlock reminding you that the vehicle is not
in P (Park) or the ignition is on.

Autolock feature (if enabled)

The autolock feature will lock all the doors when:
• all the doors are closed,
• the ignition is on,
• you shift into any gear putting the vehicle in motion, and
• the vehicle attains a speed greater than 12 mph (20 km/h).
The autolock feature repeats when:
• any door is opened then closed while the ignition is on and the vehicle

speed is 9 mph (15 km/h) or lower, and

• the vehicle then attains a speed greater than 12 mph (20 km/h).
Deactivating/activating autolock feature

Your vehicle comes with the autolock feature activated; there are three
methods to enable/disable this feature:
• Through your authorized dealer,
• using a keypad procedure (if equipped), or
• by using the instrument cluster message center (if equipped). Refer to

Message center in the Instrument Cluster chapter.

Note: The autolock feature can be activated/deactivated independently
of the autounlock feature.

Keyless entry keypad autolock enable/disable procedure

1. Turn the ignition off.

2. Close all the doors.

3. Enter factory–set 5–digit entry
code.

4. Press and hold the 3

• 4. While holding the 3 • 4 press the 7 • 8.

5. Release the 7

• 8.

6. Release the 3

• 4.

The user should receive a horn chirp to indicate the system has been
disabled or a chirp followed by a honk to indicate the system has been
enabled.

Locks and Security

123

2011 Edge (edg)
Owners Guide, 2nd Printing
USA
(fus)

Advertising