Trailer sway control, Driving – FORD 2011 Edge v.2 User Manual

Page 249

Advertising
background image

AdvanceTrac

Features

Control switch
operation

Mode

Stability

control

light

(

)

Message

center display

TCS

Default at
start-up

System

initialization

Turns on

at

start-up

None

Enabled

Pressed once,
momentarily

Traction

control off

On

TRACTION

CONTROL OFF

Disabled

Pressed again
after deactivation

AdvanceTrac

fully enabled

Off

ADVANCETRAC

ON

Enabled

Note: The ESC/RSC

௡ systems can’t be turned on or off using the

control switch.

TRAILER SWAY CONTROL

When properly equipped, trailer sway control will use the vehicle’s
AdvanceTrac

௡ with RSC௡ system to detect and help reduce trailer sway

by applying brake force at individual wheels and, if necessary, by
reducing engine power. Trailer sway control is only enabled above
40 mph (64 km/h).

WARNING: Trailer sway control does not prevent a trailer from
swaying. It mitigates the sway from increasing once it has

occurred. If you are experiencing trailer sway, it is likely that the
trailer is improperly loaded for the correct tongue weight or the speed
of the vehicle and trailer is too high. Pull the vehicle-trailer over to a
safe location to check the trailer weight distribution and tongue load,
and reduce speed to a safe level while towing. If trailer sway is
experienced, SLOW DOWN.

During trailer sway control events, the stability control light in the
instrument cluster will flash momentarily. The message center will also
display TRAILER SWAY REDUCE SPEED. In some cases when trailer
sway is detected, the vehicle speed is too high and may be at or above a
speed at which trailer sway will grow continuously. This may cause the
system to activate multiple times, and you may experience a slight
deceleration of the vehicle.

Driving

249

2011 Edge (edg)
Owners Guide, 2nd Printing
USA
(fus)

Advertising