FORD 2011 Edge v.2 - Manual (Page 134)

Note: If the vehicle has been remote started and is equipped with an IKT,
you must turn the ignition on before driving the vehicle. If equipped with an
IA transmitter, you must press the START/STOP button on the instrument
panel once while applying the brake pedal before driving the vehicle.
The power windows will be inhibited during the remote start and the
radio will not turn on.
The parking lamps will remain on and the engine will run for 5, 10, or
15 minutes, depending on how you programmed the system. To select
the duration of the remote start system refer to Message center in the
Instrument Cluster chapter.
Extending the engine run time
To keep the engine running for another remote start duration, repeat
Steps 1 and 2 with the engine still running. If you programmed the
duration to last 10 minutes, the second 10 minutes will begin
immediately so that, for example, if the vehicle had been running from
the first remote start for five minutes, the engine will continue to run for
a total of 15 minutes. You can only extend the remote start once.
The ignition must be turned on and then back off or allow one hour to pass
before using remote start again if additional remote starts are desired.
Turning the engine off after using remote start
• Press
one time. The parking lamps will turn off.
You may have to be closer to the vehicle than when starting due to
ground reflection and the added noise of the running engine.
You can disable or enable the remote start system through the message
center. Refer to Message center in the Instrument Cluster chapter.
SECURICODE™ KEYLESS ENTRY SYSTEM (IF EQUIPPED)
You can use the keyless entry
keypad to:
• lock or unlock the doors without
using a key.
• recall memory seat/power mirrors
positions (if equipped).
• enable/disable autolock and autounlock.
• program/erase user codes.
• arm/disarm the perimeter alarm system.
Locks and Security
134
2011 Edge (edg)
Owners Guide, 2nd Printing
USA (fus)