Homelink, Universal transceiver (if so equipped) -59, Programming homelink – NISSAN 2012 Armada - Owner's Manual User Manual

Page 152

Advertising
background image

The HomeLink

ா Universal Transceiver provides a

convenient way to consolidate the functions of up
to three individual hand-held transmitters into
one built-in device.

HomeLink

ா Universal Transceiver:

● Will operate most Radio Frequency (RF)

devices such as garage doors, gates, home
and office lighting, entry door locks and se-
curity systems.

● Is powered by your vehicle’s battery. No

separate batteries are required. If the vehi-
cle’s battery is discharged or is discon-
nected, HomeLink

ா will retain all program-

ming.

Once the HomeLink

Universal Transceiver

is programmed, retain the original trans-
mitter for future programming procedures
(Example: new vehicle purchases). Upon
sale

of

the

vehicle,

the

programmed

HomeLink

Universal Transceiver buttons

should be erased for security purposes. For
additional information, refer to “Program-
ming HomeLink

” later in this section.

WARNING

Do not use the HomeLinkUniversal

Transceiver

with

any

garage

door

opener that lacks safety stop and re-
verse features as required by federal
safety standards. (These standards be-
came

effective

for

opener

models

manufactured after April 1, 1982). A ga-
rage door opener which cannot detect
an object in the path of a closing garage
door and then automatically stop and
reverse, does not meet current federal
safety standards. Using a garage door
opener

without

these

features

in-

creases the risk of serious injury or
death.

During the programming procedure

your garage door or security gate will
open and close (if the transmitter is
within range). Make sure that people or
objects are clear of the garage door,
gate, etc. that you are programming.

Your vehicle’s engine should be turned

off while programming the HomeLink

Universal Transceiver.

PROGRAMMING HOMELINK

1. To begin, press and hold the two outer

HomeLink

ா buttons (to clear the memory)

until the indicator light

1

blinks (after 20

seconds). Release both buttons.

2. Position the end of the hand-held transmitter

1 - 3 inches (26 - 76 mm) away from the
HomeLink

ா surface.

WIC0986

HOMELINK

UNIVERSAL

TRANSCEIVER (if so equipped)

Instruments and controls

2-59

Advertising
This manual is related to the following products: