NISSAN 2012 Armada - Owner's Manual - Manual (Page 153)

3. Using both hands, simultaneously press and
hold both the HomeLink
ா button you want to
program and the hand-held transmitter but-
ton.
DO NOT release the buttons until step 4 has
been completed.
4. Hold down both buttons until the indicator
light on the HomeLink ா flashes, changing
from a “slow blink” to a “rapidly flashing
blink”. This could take up to 90 seconds.
When the indicator light flashes rapidly, both
buttons may be released. The rapidly flash-
ing light indicates successful programming.
To activate the garage door or other pro-
grammed device, press and hold the pro-
grammed HomeLink
ா button — releasing
when the device begins to activate.
5. If the indicator light on the HomeLink
ா blinks
rapidly for 2 seconds and then turns solid,
HomeLink
ா has picked up a “rolling code”
garage door opener signal. You will need to
proceed with the next steps to train the
HomeLink
ா to complete the programming
which may require a ladder and another per-
son for convenience.
6. Press and release the “smart” or “learn” pro-
gram button located on the garage door
opener’s motor to activate the “training
mode”. This button is usually located near
the antenna wire that hangs down from the
motor. If the wire originates from under a
light lens, you will need to remove the lens to
access the program button.
NOTE:
Once you have pressed and released the
program button on the garage door open-
er’s motor and the “training light” is lit, you
have 30 seconds in which to perform step 7.
Use the help of a second person for conve-
nience to assist when performing this step.
7. Within 30 seconds of pressing and releas-
ing the garage door opener’s program but-
ton, quickly and firmly press and release the
HomeLink
ா button you’ve just programmed.
Press and release the HomeLink
ா button up
to 3 times to complete the training.
8. Your HomeLink
ா button should now be pro-
grammed. (To program the remaining
HomeLink
ா buttons for additional door or
gate openers, follow steps 2-4 only.)
NOTE:
Do not repeat step 1 unless you want to
“clear”
all previously programmed
HomeLink ா buttons.
If you have any questions or are having difficulty
programming your HomeLink
ா buttons, refer to
the HomeLink ா web site at: www.homelink.com
or call 1-800-355-3515.
PROGRAMMING HOMELINK
ா FOR
CANADIAN CUSTOMERS
Prior to 1992, D.O.C. regulations required hand-
held transmitters to stop transmitting after 2 sec-
onds. To program your hand-held transmitter to
HomeLink
ா, continue to press and hold the
HomeLink
ா button (see steps 2 - 4 under “Pro-
gramming HomeLink
ா”) while you press and re-
press (“cycle”) your hand-held transmitters every
2 seconds until the indicator light flashes rapidly
(indicating successful programming).
WIC0987
2-60 Instruments and controls