Baumer Speed switches DSL - Manual (Page 12)

Baumer_DSL-WinXP_MA_ENBaumer_DSL-WinXP_MA_EN.doc 12/22 Baumer Hübner GmbH
01.11.2010 / bja Berlin, Germany
6.2 Status window
Fig. 10: Status window
The status window (Fig. 10) shows the current speed of the connected
device and the states of the three outputs (DSL.R) or the three relays
(DSL.E) through indicator lights.
• Indicator light is green:
Relay is closed and at least a current of 5 mA flows (DSL.E), or
switched output is high (DSL.R).
• Indicator light is yellow:
Relay is closed but no current or less than a current of 5 mA flows
(DSL.E), or switched output is high (DSL.R).
• Indicator light is red:
Relay is open, or switched output is low.
The reason for the open relay or low switched output is shown below
the red indicator.
The following causes are possible for a DSL.R:
− Speed (exceeded the switch-off speed)
− Internal error (wrong number of pulses, or initialization error)
The following causes are possible for a DSL.E:
− Speed (exceeded the switch-off speed)
− Internal error (wrong number of pulses, or initialization error)
− I-control (appearing at R1 and R2): there is no current flowing
through the control circuit, even though relay C1 is closed.
− I-output 1 or 2 (appearing at check output C1): there is no
current flowing through the circuit of R1 or R2, even though the
relay is closed.
Because of the serial data transmission between the device and the PC, there may be a delay
before the output states are displayed.