Baumer Speed switches DSL - Manual (Page 17)

Baumer_DSL-WinXP_MA_ENBaumer_DSL-WinXP_MA_EN.doc 17/22 Baumer Hübner GmbH
01.11.2010 / bja Berlin, Germany
Fig. 15: New password
7 Log-in
Before switching speeds can be programmed or errors can be deleted, a
log-in is required. To do this, it is necessary to enter a user name
(Fig. 14).
This name is stored in the DSL and in the
C:\DSL_Parameter.txt log file. If the DSL is protected by a
password, this password will also be requested.
After entering the user name and (if required) the password, the user
can choose between Log-in and Log-in and new password.
If more characters are entered for the user name and password than the maximum number
permitted (15 or 8 respectively), the string will automatically be cut off at the maximum length.
Special characters may be used, and a distinction is made between capital (upper-case) and
lower-case letters.
The device is delivered without password protection.
An incorrect password triggers an error message, and the log-in window remains open until either the correct
password is entered or Cancel is operated.
If Log-in and new password is chosen, then a new entry template appears (Fig. 15), with the request to enter
the new password twice.
To cancel a password protection that has been entered,
leave both fields empty.
If Cancel is operated in this template, then the user remains logged in to
the device with the old password.
An alteration to a password is recorded in the
C:\DSL_Parameter.txt log file, but the password itself is not
recorded here.
Fig. 14: Log-in