Baumer N 155 - Manual (Page 12)

N 155
www.baumer.com 12
Example 2: Changing the measuring unit into inch
SOH Adr Cmd Data EOT CRC
Send
01h 20h 69h 31h 04h D2
SOH Adr Cmd Data EOT CRC
Response
01h 20h 69h 31h 04h D2
Example 3: Programming mm as measuring unit with all target displays by broadcast command (Adr=99)
SOH Adr Cmd Data EOT CRC
Send
01h 83h 69h 30h 04h CDh
Response No confirmation
Important: Parameter programming is in mm. The target display will convert the mm into inches when display-
ing the position values.