Crestron electronic Residential Lighting - Manual (Page 16)

Crestron Residential Lighting Design Guide GreenLight Options–CAEN Enclosures
Doc. 5999F 11
Green Light Options
CAEN- Series Enclosures
The CAEN Series automation enclosures are designed to house
the Crestron CLX-series of lighting and motor control modules
and
PAC2 or PAC2M control systems. CAEN enclosures are
available in an assortment of sizes, suitable for surface or flush
wall mount installation. Each model has been engineered to
provide a clean and manageable installation with abundant
provisions for wire termination and electrical knockouts.
CAEN automation enclosures are designed to use space
efficiently by supporting over a hundred possible circuits in the
largest model. Both centralized and distributed configurations
are possible. A single PAC2 control system installed in a
central enclosure can support numerous satellite extension
enclosures distributed throughout a residence or commercial
facility. Interconnection of the complete network of enclosures
requires just one circulating Cresnet® cable. Dozens of
keypads, touchpanels, wall box dimmers, shade controllers,
and other peripherals can also be terminated within an
enclosure, with separate compartments provided for high and
low voltage wiring.
Crestron lighting and automation systems are completely
convection cooled for silent and reliable operation. A vented
front cover is included with every enclosure.
All models are constructed of 16-gauge galvanized steel and
are pre-drilled for mounting of the PAC2, PAC2M, terminal
blocks, CLX modules, CLT power supplies, and CAEN-BLOCK
terminal block.
Additional non-CLX lighting modules and third-party contactors
may be installed using CAEN-UMP Crestron universal mounting
plates. Grounding blocks and low voltage partitions included.
CAEN enclosures are also well suited for all types of Class 2
and Class 3 applications including voice and data structured
wiring, security, and RF signal distribution (as permitted by
applicable codes).
CAEN enclosures are UL and C-UL listed. If you require a
complete UL listed panel, Crestron offers this service through
its UL508 listed panel shop, providing complete in-factory
system configuration and assembly.
NOTE: The PAC2 occupies two module spaces in a double-
wide enclosure and one module space in a single-wide.
NOTE: Four keyholes are located within the enclosure and
should be used if surface mounting.