Cisco Linksys SPA9000 - Manual (Page 183)

6-35
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 6 SPA9000 Field Reference
Regional Tab
Miscellaneous
Field Description
Set Local Date (mm/dd) Sets the local date (mm stands for months and dd stands for days). The year is optional
and uses two or four digits.
Set Local Time (HH/mm) Sets the local time (hh stands for hours and mm stands for minutes). Seconds are optional.
Time Zone Selects the number of hours to add to GMT to generate the local time for caller ID
generation. Choices are GMT-12:00, GMT-11:00,…, GMT, GMT+01:00, GMT+02:00,
…, GMT+13:00.
The default is GMT-08:00.
FXS Port Impedance Sets the electrical impedance of the FXS port. Choices are 600, 900, 600+2.16uF,
900+2.16uF, 270+750||150nF, 220+850||120nF, 220+820||115nF, or
200+600||100nF .
The default is 600.
Daylight Saving Time Rule Enter the rule for calculating daylight saving time; it should include the start, end,
and save values. This rule is comprised of three fields. Each field is separated by ; (a
semicolon) as shown below. Optional values inside [ ] (the brackets) are assumed to
be 0 if they are not specified. Midnight is represented by 0:0:0 of the given date.
This is the format of the rule: Start = <start-time>; end=<end-time>; save =
<save-time>.
• The <start-time> and <end-time> values specify the start and end dates and times of
daylight saving time. Each value is in this format: <month> /<day> /
<weekday>[/HH:[mm[:ss]]]
• The <save-time> value is the number of hours, minutes, and/or seconds to add to the
current time during daylight saving time. The <save-time> value can be preceded by
a negative (-) sign if subtraction is desired instead of addition. The <save-time> value
is in this format: [/[+|-]HH:[mm[:ss]]]
• The <month> value equals any value in the range 1-12 (January-December).
• The <day> value equals [+|-] any value in the range 1-31.
• If <day> is 1, it means the <weekday> on or before the end of the month (in other
words the last occurrence of < weekday> in that month).
• The <weekday> value equals any value in the range 1-7 (Monday-Sunday). It can
also equal 0. If the <weekday> value is 0, this means that the date to start or end
daylight saving is exactly the date given. In that case, the <day> value must not be
negative. If the <weekday> value is not 0 and the <day> value is positive, then
daylight saving starts or ends on the <weekday> value on or after the date given. If
the <weekday> value is not 0 and the <day> value is negative, then daylight saving
starts or ends on the <weekday> value on or before the date given.
• The abbreviation HH stands for hours (0-23).
• The abbreviation mm stands for minutes (0-59).
• The abbreviation ss stands for seconds (0-59).
The default Daylight Saving Time Rule is start=4/1/7;end=10/-1/7;save=1.