Cisco Linksys SPA9000 - Manual (Page 200)

6-52
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 6 SPA9000 Field Reference
Line 1/2/3/4 Tab
Dial Plan
The default dial plan script for each line is as follows:
(*xx|[3469]11|0|00|[2-9]xxxxxx|1xxx[2-9]xxxxxx|xxxxxxxxxxxx.). The syntax for a dial plan
expression is as follows:
If IP dialing is enabled, one can dial [user-id@]a.b.c.d[:port], where ‘@’, ‘.’, and ‘:’ are dialed by
entering *, user-id must be numeric (like a phone number) and a, b, c, d must be between 0 and 255, and
port must be larger than 255. If port is not given, 5060 is used. Port and User-Id are optional. If the
user-id portion matches a pattern in the dial plan, then it is interpreted as a regular phone number
according to the dial plan. The INVITE message, however, is still sent to the outbound proxy if it is
enabled.
Contact List (cont.) Default is blank.
Since version 3.2.8, SPA9000 supports Phone Extension to DID Number Mapping
through an added syntax in this parameter. If such mapping is provided for a given
extension, the user-id and display name fields in the FROM and REFERRED-BY headers
(wherever applied) of outbound requests originated from that phone to the ITSP are
replaced by the corresponding DID number and the phone’s assigned display name
respectively. If the mapping is not provided, the SPA9000 uses the line interface’s user-id
and display name instead (old behavior). To specify the mapping from Extension to DID,
insert a ‘+’ or ‘-’ in front of the ext of a rule. The ext must not include any wildcard
characters. If ‘+’ is used, the ext is alerted when the corresponding DID is called (just like
the case without the ‘+’ prefix). If ‘-’ is used, the ext is not be alerted (that is, it is only
there to define a ext-to-DID-mapping). Note that ‘+’ or ‘-’ may be assigned to more than
one ext in the same rule. For example:
4089991002:1001,+1002|4089991008:aa,-1008
For this example, when 1002 makes an external call, the FROM user-id shows
4089991002. When 1008 makes an external call, the FROM user-id shows 4089991008.
When 4089991002 is called, both 1001 and 1002 are alerted. When 4089991008 is called,
only the AA is alerted.
Cfwd No Ans Delay Delay, in seconds, before the call forwarding of no-answer calls feature is triggered.
The default is 20.
Table 6-1 Dial Plan Script Syntax
Dial Plan Entry Functionality
*xx Allow arbitrary 2 digit star code
[3469]11 Allow x11 sequences
0 Operator
00 Int’l Operator
[2-9]xxxxxx US local number
1xxx[2-9]xxxxxx US 1 + 10-digit long distance number
xxxxxxxxxxxx. Everything else (Int’l long distance, FWD, ...)