Dell PowerVault MD3420 - Manual (Page 282)

Parameters
Parameter Description
enclosureID Identifies a specific enclosure for which to set the
attribute. Enclosure ID values are 0 to 99. You must
put brackets ([ ]) around the enclosure ID value.
chassisName Chassis name or number to give the new
enclosure. Chassis names can be any combination
of alphanumeric characters with a maximum
length of 32 characters. Alphabetical characters
can be uppercase or lowercase. You can also use
the underscore character (_) and the hyphen (
‑)
character. You cannot use spaces in a chassis
name. You must put quotation marks (" ") around
the chassis name.
assetTag Asset tag name or number to give the new
enclosure. Asset tags can be any combination of
alphanumeric characters with a maximum length
of ten characters. Alphabetical characters can be
uppercase or lowercase. You can also use the
underscore character (_) and the hyphen (
‑)
character. You cannot use spaces in an asset tag
name. You must put quotation marks (" ") around
the asset tag name.
Set Enclosure Identification
Description
This command sets the ID of an enclosure in a storage array.
Syntax
set enclosure ["Service Tag"] id=enclosureID
Parameters
Parameter Description
enclosure Service tag of the RAID enclosure or the expansion
enclosure for which you are setting the enclosure
ID. You must put quotation marks (" ") around the
Service Tag.
id Specifies the value for the RAID enclosure or
expansion enclosure ID. Valid values are 0 through
99. You do not need to put parentheses around
the enclosure ID value.
282