Dell PowerVault MD3420 - Manual (Page 301)

Passwords are stored on each storage array in a management domain. If a password was not previously
set, you do not need a password. The password can be any combination of alphanumeric characters with
a maximum of 30 characters. (You can define a storage array password by using the set storageArray
command.)
The polling interval and the number of iterations that you specify remain in effect until you end the
session. After you end the session, the polling interval and the number of iterations return to their default
values.
Set Snapshot Group Attributes
Description
This command defines the properties for a snapshot group.
Syntax
set snapGroup ["snapGroupName"]
[userLabel="snapGroupName" |
repositoryFullPolicy=(failBaseWrites | purgeSnapImages) |
repositoryFullLimit=percentValue |
autoDeleteLimit=numberOfSnapImages |
rollbackPriority=(lowest | low | medium | high | highest)
Parameters
Parameter Description
snapGroup The alphanumeric identifier (including - and _) of
the snapshot group for which you are setting
properties. Enclose the snapshot group name in
double quotation marks (" ") inside of square
brackets ([ ]).
userLabel The new alphanumeric identifier (including - and _)
that you want to give to the snapshot group. Use
this parameter when you want to rename the
snapshot group. Enclose the new snapshot group
name in double quotation marks (" ").
repositoryFullPolicy How you want snapshot image processing to
continue if the repository virtual disks for the
snapshot image group are full. You can choose to
fail writes to the base virtual disk
(failBaseWrites) or delete (purge) the snapshot
images (purgeSnapImages). The default action is
purgeSnapImages.
repositoryFullLimit The percentage of repository virtual disk capacity
at which you receive a warning that the snapshot
image repository virtual disk is nearing full. Use
integer values. For example, a value of 70 means
70 percent. The default value is 75.
301