Dell Alienware 14 (Mid 2013) - Manual (Page 17)

Replacing the Memory Module(s) | 17
Replacing the Memory Module(s)
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. After working inside your computer,
follow the instructions in "After Working Inside Your Computer" on
page 11. For additional safety best practices information, see
the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the notch on the memory module with the tab on the memory-module
connector.
2 Slide the memory module firmly into the slot at a 45-degree angle, and press the
memory module down until it clicks into place. If you do not hear the click, remove
the memory module and reinstall it.
NOTE: If the memory module is not installed properly, the computer may
not boot.
Postrequisites
1 Replace the battery. See "Replacing the Battery" on page 15.
2 Replace the base cover. See "Replacing the Base Cover" on page 13.
3 Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 17 Monday, June 24, 2013 10:53 AM