Dell Alienware 14 (Mid 2013) - Manual (Page 87)

Replacing the Display Light Boards | 87
Replacing the Display Light Boards
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. After working inside your computer,
follow the instructions in "After Working Inside Your Computer" on
page 11. For additional safety best practices information, see
the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the display light boards with the screw holes on the display
back-cover.
2 Replace the screws that secure the display light boards to the display back-cover.
3 Route the camera cable on the display back-cover and adhere the cable into place.
4 Connect the camera cable to the camera-module connector.
5 Adhere the Mylar on the display light boards.
Postrequisites
1 Replace the logo board. See "Replacing the Logo Board" on page 84.
2 Replace the display panel. See "Replacing the Display Panel" on page 78.
3 Replace the display hinges. See "Replacing the Display Hinges" on page 74.
4 Replace the display bezel. See "Replacing the Display Bezel" on page 72.
5 Replace the display assembly. See "Replacing the Display Assembly" on page 70.
6 Follow the instructions from step 5 to step 10 in "Replacing the Palm Rest" on
page 36.
7 Follow the instructions from step 8 to step 10 in "Replacing the Secondary Hard-Drive
(optional)" on page 22.
8 Replace the battery. See "Replacing the Battery" on page 15.
9 Replace the base cover. See "Replacing the Base Cover" on page 13.
10 Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 87 Monday, June 24, 2013 10:53 AM