Dell Alienware 14 (Mid 2013) - Manual (Page 31)

Replacing the mSATA card | 31
Replacing the mSATA card
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. After working inside your computer,
follow the instructions in "After Working Inside Your Computer" on
page 11. For additional safety best practices information, see
the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the notch on the mSATA card with the tab on the system-board connector.
CAUTION: Use firm and even pressure to slide the mSATA card into
place. If you use excessive force, you may damage the connector.
CAUTION: The connectors are keyed to ensure correct insertion. If
you feel resistance, check the connectors on the mSATA card and on
the system-board connector, and realign the mSATA card.
2 Insert the mSATA card at a 45-degree angle into the system-board connector.
3 Press the other end of the mSATA card down into the slot on the system board and
replace the screw that secures the mSATA card to the system board.
Postrequisites
1 Replace the battery. See "Replacing the Battery" on page 15.
2 Replace the base cover. See "Replacing the Base Cover" on page 13.
3 Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 31 Monday, June 24, 2013 10:53 AM