Dell Alienware 14 (Mid 2013) - Manual (Page 70)

70 | Replacing the Display Assembly
Replacing the Display Assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
"Before You Begin" on page 9. After working inside your computer,
follow the instructions in "After Working Inside Your Computer" on
page 11. For additional safety best practices information, see
the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the display assembly with the screw holes on the computer
base.
2 Replace the screws that secure the display assembly to the computer base.
3 Slide the cables through the slots on the computer base.
4 Close the display and turn the computer over.
5 Route the display, camera, and antenna cables through the routing guides.
6 Replace the screws that secure the display assembly to the computer base.
7 Connect the display and camera cables to the system-board connectors.
8 Connect the antenna cables to the wireless mini-card.
Postrequisites
1 Follow the instructions from step 5 to step 10 in "Replacing the Palm Rest" on
page 36.
2 Follow the instructions from step 8 to step 10 in "Replacing the Secondary Hard-Drive
(optional)" on page 22.
3 Replace the battery. See "Replacing the Battery" on page 15.
4 Replace the base cover. See "Replacing the Base Cover" on page 13.
5 Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 70 Monday, June 24, 2013 10:53 AM