Dell 1320c Network Color Laser Printer - Manual (Page 32)

Port Settings
Purpose:
To specify whether to enable or disable printing ports and management protocol features.
Values:
TCP/IP
Purpose:
To configure the IP address, subnet mask, and gateway address of the printer.
Values:
Administrator E-Mail
Address Specifies the contact address of the printer administrator and service center up to 63 alphanumeric characters.
Asset Tag Number Enter the asset tag number for the printer.
EWS Settings Auto Refresh On Refreshes the contents of the status display pages automatically.
Off Does not refresh the status display pages automatically.
Auto Refresh Interval Sets the time interval for refreshing the contents of the status display pages automatically from 15 to 600
seconds.
NOTE: The auto refresh feature is effective for the contents of the Top Frame, Printer Status page, Job List page, and Completed Jobs page.
Ethernet Ethernet
Settings Auto Detects Ethernet transmission rate and the duplex settings automatically.
10Base-T
Half-Duplex Selects 10Base-T Half-Duplex as the default value.
10Base-T
Full-Duplex Selects 10Base-T Full-Duplex as the default value.
100Base-TX Half-
Duplex Selects 100Base-TX Half-Duplex as the default value.
100Base-TX Full-
Duplex Selects 100Base-TX Full-Duplex as the default value.
Current Ethernet Settings Displays the current settings of Ethernet.
MAC Address Displays the printer's MAC address.
Port
Status LPD Select the check box to enable the LPD.
Port9100 Select the check box to enable the Port9100.
FTP Select the check box to enable the FTP port.
E-Mail Alert Select the check box to enable the E-Mail Alert feature.
SNMP Agent Select the check box to enable the SNMP (Simple Network Management Protocol).
You can also configure the transport protocol to be used. UDP can be selected as the transport
protocol.
NOTE: The settings in the Port Settings page will be valid only when the printer is rebooted. When you change or configure the settings, click the
Restart printer to apply new settings button to apply new settings.
TCP/IP
Settings Host Name Specifies the host name up to 47 alphanumeric characters. The default name will remain valid if no entry is made.
IP Address
Mode AutoIP Automatically sets the IP address.
DHCP Uses DHCP to set the IP address.
BOOTP Uses BOOTP (BOOTstrap Protocol) to set the IP address.