Dell 1320c Network Color Laser Printer - Manual (Page 65)

Paper Density
Purpose:
To specify the paper density.
Power Saver
Timer Mode 2
*1
5-60 min Specifies the amount of time before the printer enters the Power Saver Timer Mode 2 (deep sleep mode) when
the times specified in Power Saver Timer Mode 1 and Power Saver Timer Mode 2 elapses after a print job is
complete.
10 min*
Alert Tone Control Panel
Tone Off* Does not sound an alert when you press a button on the panel.
On Sounds an alert when you press a button on the panel.
Machine Ready
Tone Off* Does not sound an alert when the printer is ready.
On Sounds an alert when the printer is ready.
Job Complete
Tone Off* Does not sound an alert when a job is completed.
On Sounds an alert when a job is completed.
Fault Tone Off* Does not sound an alert when a job is terminated by some faults.
On Sounds an alert when a job is terminated by some faults.
Alert Tone Off* Does not sound an alert when an error occurs.
On Sounds an alert when an error occurs.
Out of Paper
Alert Tone Off* Does not sound an alert when the printer runs out of paper.
On Sounds an alert when the printer runs out of paper.
Low Toner Alert
Tone Off* Does not sound an alert when toner becomes low.
On Sounds an alert when toner becomes low.
Time-Out 0 Disables the job timeout.
5-300 sec Specifies the amount of time the printer waits to receive additional bytes of data from the computer. When this
timeout expires, the print job is canceled.
30 sec*
Device Language English* Determines the language to be used for E-mail Alert.
French
Italian
German
Spanish
Dutch
Danish
Norwegian
Swedish
Finnish
Polish
Portuguese
Japanese
Turkish
Auto Log Print Off* Does not automatically print the Job History report.
On Automatically print the Job History report when the number of Job History items reaches the maximum.
Apply New Settings After you complete the settings, press the Apply New Settings button to apply the changes.
Restart printer to apply new settings Press the Restart printer to apply the new settings button to apply the changes.
*1 Enter 3 to put the printer in the power saver timer mode five minutes after it finishes a job. This uses much less energy, but requires more warm-
up time for the printer. Enter 3 if your printer shares an electrical circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer ready to operate with minimum warm-up time.
Select a value between 5 and 60 minutes for the power saver timer mode if you want a balance between energy consumption and a shorter warm-up
period.
The printer automatically returns to the standby mode from the power saver timer mode when it receives data from the computer. You can also return
the printer to the standby mode by pressing any button on the operator panel.