Part of the print is too light – Dell 1320c Network Color Laser Printer User Manual
Page 90
Part of the print is too light.
the printer driver.
Ensure Non-Dell Toner is not selected in the Printer
Maintenance tab in the Tool Box.
1.
Click the Tool Box button.
Set Toner Saving Mode to Off in the printer driver.
1.
Press [Printing Preferences], and then click the
Advanced tab.
If you are printing on an uneven print surface, change the
paper type setting in the printer driver. For example,
change the plain paper to thick.
1.
Press [Printing Preferences], and then click the Paper
Tray tab.
Verify that the correct print media is being used.
1.
See "
Print Media Sizes and Support
".
Ensure that eight yellow ribbons are correctly removed
from the PHD (Print Head Device) unit.
1.
See "
Replacing the PHD (Print Head Device) Unit
" and
"
Installing the PHD Unit
".
Ensure that the developer motor starts.
1.
Contact Dell.
Ensure that the dispense motor starts.
1.
Contact Dell.
When you are printing many images with low density, do
the Toner Refresh Mode.
1.
Click the Tool Box button.
2.
Press the Start button to check the density of colors.
3.
If the print is too light, Select Refresh Mode from the
list. Press the Start(1)-(4) buttons.
CAUTION:
Using the Refresh Mode consumes extra toner.
4.
After you complete the Refresh Mode, select Chart
Print from the list. Press the Print with A4(3) or Print
with Letter(C) button for 4 Colors Configuration Chart.
"Printing" appears.
Is the problem recovered?
Yes. The task is complete.
No. The PHD unit is old or damaged. Replace the PHD unit.
Try the spare PHD unit, if possible.
1.
Replace the PHD unit. See "
Replacing the PHD (Print
Head Device) Unit
" and "
Installing the PHD Unit
".
2.
After you replace the PHD unit, click the Tool Box
button.
3.
Press the Print with A4(3) or Print with Letter(C)
button.
Is the problem recovered?
Yes. The PHD unit is old or damaged. Replace the PHD unit.
No. Contact Dell.
Contact Dell.
1.
Contact Dell.
When you are printing many images with low density, do
the Toner Refresh Mode.
1.
Click the Tool Box button.
2.
Press the Start button to check the density of colors.