Crestron electronic TPMC-8T - Manual (Page 34)

Isys i/O™ 8.4” TableTop WiFi Touchpanel Crestron TPMC-8T
The following are the events that can be selected:
1. Error: An error occurred while trying to identify the swiped finger. It
could be any of the events listed below from #6 through #13.
2. Finger detected: A finger has been detected and identification will start.
3. Identifying: The sensor is in the process of identifying.
4. Match: Identification has completed and a match has been found.
5. No-match: Identification has completed and no match was found in the
user database.
6. Surface dirty: The surface is too dirty for identification.
7. Swipe too far left
8. Swipe too far right
9. Swipe too fast
10. Swipe too little pressure
11. Swipe too short
12. Swipe too skewed
13. Swipe too slow
Select the event you wish to edit and touch Edit to open the “Event Biometric
Information” window.
“Event Biometric Information” Window
Touch OK to accept (or touch CANCEL to cancel) and return to the “Biometric
Configuration Properties” window. Then touch OK to return to the startup menu.
In actual use, a popup window will appear showing if a match was found, if a match
was not found or if the scan was no good (for example, too short).
Crestron Toolbox includes a utility that will allow the database from one TPMC-8T
to be shared with another, by backing up the database from one touchpanel and
restoring it to another. From Toolbox, select Functions | Biometric Data… to open
the utility, as shown in the illustration on the following page.
30 • Isys i/O™ 8.4” TableTop WiFi Touchpanel: TPMC-8T Operations Guide – DOC. 6567C