Dell POWEREDGE M1000E - Manual (Page 343)

Fabric OS MIB Reference 323
53-1002750-01
Bridge-MIB
18
dot1d static group
dot1dTpPortOutFrames
1.3.6.1.2.1.17.4.4.1.4 Read only The number of frames that have been transmitted by this port to its
segment.
NOTE: A frame transmitted on the interface corresponding to this port
is only counted by this object if and only if it is for a protocol
being processed by the local bridging function, including the
bridge management frames.
dot1dTpPortInDiscards
1.3.6.1.2.1.17.4.4.1.5 Read only The count of received valid frames that were discarded (that is,
filtered) by the forwarding process.
TABLE 122
Object and OID Access Description
dot1dStaticTable
1.3.6.1.2.1.17.5.1 Not
accessible A table containing filtering information configured into the bridge by
(local or network) management specifying the set of ports to which
frames received from specific ports and containing specific destination
addresses are allowed to be forwarded.
dot1dStaticEntry
1.3.6.1.2.1.17.5.1.1 Not
accessible The filtering information configured into the bridge by (local or network)
management specifying the set of ports to which the frames received
from a specific port and containing a specific destination address are
allowed to be forwarded.
dot1dStaticAddress
1.3.6.1.2.1.17.5.1.1.1 Read
create The destination MAC address in a frame to which this entry's filtering
information applies. This object can take the value of a unicast
address, a group address, or the broadcast address.
dot1dStaticReceivePort
1.3.6.1.2.1.17.5.1.1.2 Read
create The port number of the port from which a frame must be received in
order for this entry's filtering information to apply.
A value of zero indicates that this entry applies on all ports of the
bridge for which there is no other applicable entry.
dot1dStaticAllowedToGo
To
1.3.6.1.2.1.17.5.1.1.3 Read
create The set of ports to which frames received from a specific port and
destined for a specific MAC address, are allowed to be forwarded.
NOTE: This object is not supported.
dot1dStaticStatus
1.3.6.1.2.1.17.5.1.1.4 Read
create This object indicates the status of this entry.
Values:
•
other (1) - This entry is currently in use, but the conditions under
which it will remain so differ from the following values.
•
invalid (2) - Writing this value to the object removes the
corresponding entry.
•
permanent (3) - This entry is currently in use and will remain so
after the next reset of the bridge.
•
deleteOnReset (4) - This entry is currently in use and will remain
so until the next reset of the bridge.
•
deleteOnTimeout (5) - This entry is currently in use and will
remain so until it is aged out.
TABLE 121
Object and OID Access Description