Casio YP-100 - Manual (Page 58)

58
7 Keep clicking the [OK] button on the dialog boxes that appear.
z Clicking the [OK] button in response to the “Overwrite it?” message will cause the
settings of the first computer to be sent to the YP-100. At this time, the Manual
Connection 1 settings of the YP-100 will be overwritten with the “Test” settings of the
connection profile of the computer (see step 3 above). The IP address setting will be the
IP address of the computer's connection profile plus 1.
8 To return to the Send Settings dialog box, click the [Cancel] button.
9 Click the [Close] button.
z This will cause the dialog box shown below to appear.
10 On the YP-100 remote controller, press the [ ] key.
z This will cause the connection profile menu to appear in the projection area.
11 Use the [
T T T T] key to move the highlighting to “Manual Connection 1” and then
press the [ENTER] key.
z This will display the dialog box shown below.
12 Press the [
S S S S] key to move the highlighting to “Yes” and then press the [ENTER]
key.
z This will cause the message shown below to appear in the projection area.
Check to make sure that “Manual Connection 1
(Test)” is shown.