Pro-Ject Audio Systems Pro-Ject Signature 12 - Manual (Page 4)

3. Idler pulley assembly
Idler pulley consists of two parts. One is powered by the motor units and one is floated on the magnetic
cushion. Both parts form a whole stored on a common shaft. Before installing this kit remove the covers from
the shaft and bearing. Check for adequate lubrication. If necessary, lubricate with grease in the attached
accessories.
4. Drive belt assembly
Drive belts (4) fitting in order: front drive - idler pulley (3)
rear drive - idler pulley (3)
Drive belt (7) idler pulley (3) - platter (1)
WARNING:
Don’t stretch belts too much to avoid damage.