Chariot Carriers CX - Manual (Page 19)

19
2.4 Rear Battery Lights (Accessory, not supplied as standard)
In the upper area of the rear cover there is a sewn-on webbing strap on the right
and on the left for attaching rear battery lights. When using the trailer in the dark,
an additional rear light is required by law. If only one battery light is attached, it
needs to be on the left hand side in direction of travel (in countries where the traf-
fic drives on the left the battery light must be attached to the webbing strap on the
right hand side). Flashing lights are prohibited in some countries, e.g. in Germany.
Note:
Please ensure when buying lights that they conform to the appropriate legal
requirements of the country they are used in and also bear an approval mark
(e.g. K-mark in Germany).
Push the securing pin from the top
through both holes of the aluminium cup
and secure the pin by pulling the hole of
the elastic ribbon over the protruding
end of the pin.
Safety Recommendation:
Always attach the safety strap to the
chain stay!
Put the safety strap around the bicycle
chain stay and attach the safety clip to
the D-ring of the hitch arm
Warnings regarding both Chariot hitches:
When turning round or manoeuvring the outfit, the angle between the towing bicycle and the trailer must not exceed 90°,
otherwise the hitch ball could be damaged (overstretched).
2.3.3 Fixing the Weber hitches on the bicycle
Please read carefully the comprehensive manufacturer’s instructions which are
supplied by Weber with the hitch with adjustable kickstand (Weber B) and with the
Weber hitch for rear-axle attachment (Weber E).
Attaching the trailer (identical for quick
release axle and solid axle): Insert the
hitch ball, which is attached to the
hitch arm, from the front into the alumi-
nium hitch cup.
Pull the hitch ball to the end of the
hitch cup.