Chariot Carriers CX - Manual (Page 25)

25
Push the short end of the drawbar into
the attachment bracket. Once the holes
of the attachment bracket and the draw-
bar are aligned with each other (the end
of the drawbar is visible), push the secu-
ring pin from below through bracket and
drawbar and lock it by pushing the clip
over the pin.
The holes in the drawbars are larger
than the safety snap pins, so that the
drawbars can turn slightly around their
longitudinal axis (in order to adapt to
narrow or wide hips).
at the back strap on top for adjusting
the height of the hip strap
and at the hip strap itself.
5.2 Safety Instructions for the Hiking Kit
(see also section 8 "General Safety Instructions”):
• Always make sure that the safety snap pin is fully pushed in and secure, so as to prevent the transporter from accidentally rolling.
5.1 Fitting the Hiking Kit:
5. The Hiking Kit
The assembled hiker (base + hiking kit) – example Cougar1
Parts supplied:
Drawbar with shoulder strap.
The shoulder strap, which is attached
in a similar way to that of a rucksack,
can be adjusted in three positions: at
the chest strap at the front,