Chariot Carriers CX - Manual (Page 7)

7
1.1.5 Wheel assembly on the Captain XL, Corsaire XL, Cheetah, Cougar and CX
Put the basic unit on its side. Press
on the rubber cap of the wheel axle
and insert the clevis axle into the hol-
low axle until it engages. Repeat this
on the other side.
Check that the wheel cannot be pul-
led off!
1.1.6 Fitting the handlebar (for all models except CX)
Push the handlebar into the upper open tube ends at the upper section of the carrier. Depress both spring buttons
simultaneously and insert the handlebar fully into the sleeves until the spring buttons engage. The handlebar can be height
adjusted for two different positions: Depress the spring buttons, pull out the handlebar, rotate it 180° and re-insert the
handlebar into the sleeves.
1.1.7 Fitting the handlebar on the model CX
Push the handlebar into the upper open tube ends at the upper section of the
carrier. Depress both spring buttons simultaneously and insert the handlebar fully
into the sleeves until the spring buttons engage.
Safety Recommendation:
In the event of the vehicle tipping over, the handlebar acts as a safety bar. So keep it permanently installed, even when
using the carrier behind a bicycle!