Connecting s-link to a vcr, Connecting s-link to a dbs, Note – Sony KV-32FV1 User Manual
Page 16: Connecting and installing the tv (continued)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FMf
Connecting and Installing the TV (continued)
Connecting S-Link to a VCR
S-Link will automatically power on the TV
and switch to the correct video input when a
tape is inserted in the VCR.
1
Using A/V connectors, connect AUDIO
and VIDEO OUT on your VCR to AUDIO
and VIDEO IN on your TV.
2
Using an S-Link connector (mono mini
plug), connect S-LINK on your VCR to
S-LINK/CONTROL S-OUT on your TV.
VMC-810S/820S (not supplied)
Connecting S-Link to a DBS
When you power on the DBS, S-Link will
automatically power on the TV and switch to
the correct video input.
1
Using A/V connectors, connect AUDIO
and VIDEO OUT on your DBS to AUDIO
and VIDEO IN on your TV.
2
Using an S-Link connector (mono mini
plug), connect S-LINK on your DBS to
S-LINK/CONTROL S-OUT on your TV.
Note
• If you have labeled one of your video inputs
as SKIP (see "VIDEO LABEL" on page 25)
and then connect video equipment to this
input using S-Link, the S-Link feature will
override the SKIP function.
The S-Link connector must be in the same
VIDEO-IN jacks as the A/V cables on your TV.
DBS
--m
VMf/UMF
R «UOO1. MOCO s vnco M
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
f
VMC-810S/820S (not supplied)
-t----------------------------
RK-G69HG (not supplied)
(Rear of TV)
OUT
IV
|i!№i
#
#
5