Sony KV-32FV1 - Manual (Page 32)

Operating a Cable Box or DBS Receiver
~ If the remote control doesn't work
Programming the remote
i'ou can program the supplied remote control
0 operate a cable box or DBS receiver.
1 Press CODE SET.
I Press DBS/CABLE (FUNCTION).
B Use the 0-9 buttons to key in the
manufacturer's code number from the
following chart.
\ Press ENTER.
'Or more details on operating the
'.able box or DBS receiver
lefer to the operating instructions that were
upplied with the equipment.
• First, try repeating the setup procedures
using the other codes listed for your
equipment.
Tips
•
If more than one code number is listed, try
entering them one by one until you come to the
•»^correct code for your equipment.
• If you enter a new code number, the code number
you prei'iously entered at that setting is erased.
• In some rare cases, you may not be able to operate
your equipment with the supplied remote control.
In this case, use the equipment's supplied remote
. control.
• Whenever you remove the batteries the code
numbers may revert to the factory setting.
Cable box code numbers
Manufacturer Code
Hamlin/Regal 222, 223, 224, 225, 226
Jerrold/G. I. 201, 202, 203, 204, 205, 206,
207,208,218
Oak 227, 228,229
Panasonic 219, 220, 221
Pioneer 214,215
Scientific Atlanta 209,210,211
Tocom 216,217
Zenith 212, 213
DBS receiver code numbers
Manufacturer Code
Sony
801 (preset code for
remote control)
General Electric
802
Hitachi
805
Hughes
804
Panasonic
803
RCA/PROSCAN
802, 808
Toshiba
806, 807