Sony DVP-FX810 User Manual
Page 23
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Power Connections (continued)
■ Charging the battery pack
1. Attach the battery pack to the player.
2. Connect the AC adaptor to the player and then
plug into an AC outlet.
Player Battery Pack
AC adaptor cord insert
jack (DC IN 9.5V)
Charge indicator
When charging starts, the charge Indicator lights
up In orange.
3. During recharging, the charge indicator lights up
in orange. When recharging is complete, the
Indicator turns off.
4. Disconnect the AC adaptor from the player and
pull out the plug from the AC outlet after charging.
■ Confirm the battery charge on the LCD screen
during stop.
When the charge is very low.“i; ^’’appears
and the charge Indicator flashes In orange.
The battery mark does not appear during DVD or
JPEG playback. To check the battery charge,
stop playback.
Full
C-1:
:
Low Recharge
If using the AC adaptor, battery display does not
appear.
■ Recharging and play times
o
a
Recharging (Power Off)
Playtime (DVD-VIDEO)
With player
LCD On
Approx.
5 hours and 30 minutes
Approx.
6 hours *
23
• When Backlight control is set to minimum.
- using the headphones.
- at room temperature (+25°C, +77°F).
NOTES:
• In ‘‘LINE IN” mode, the battery mark will not
appear on the screen.
• Recharging times shown above depend on operating
conditions, such as use conditions, picture brightness
and setup, operational temperature and so on.
• Charge the battery at a temperature of+5°C (+41‘’F)
to +35‘’C(+95°F).
The charging time may vary depending on the
surrounding temperature.
• The battery may not be charged when it is naturally or
purposely discharged completely, because the unit
can not perceive battery voltage, even If you attached
the battery.
When you are in this situation, power on the unit and
then power off again. Then battery charging will
proceed.