Sony KV-27TS20 - Manual (Page 18)

How to Set the Program Start TII\/tER
Make sure that the clock has been set correctly before
setting the program start TIMER.
Example: To set the TIMER for a program which begins
at 10:30 PM on channel 12
1 Press TIMER/BLOCK once
to change from “normal
page” to “clock page."
“clock page”
The TIMER lamp will light up to indicate that the TIMER
has been set.
If you have made a mistake, press CLEAR and return to
step 3.
At the preset time, the selected channel will appear on the
screen and the TIMER lamp will go out. The TIMER will
operate whether you are watching a TV program or a VCR
playback, or even if you have turned off the TV.
2 Press TIMER/BLOCK
before the “AM’T'PM”
indication disappears and
summon “TIMER page.” (TIMER SET)
■I llRM CH. Ill
8: 05 pm
It no button is pressed within 2 hours after the preset time,
an “OFF” indication will appear on the screen for 1 minute.
If a button is still not touched during the 1 minute, the TV
will turn off automatically as a safety precaution.
“TIMER page”
3 Press 1. 0, 3, 0. AM/PM,
ENTER.
Numbers will “wink” to
indicate that the time has
been set.
(TIMER SET)
10:30 pm CH.Ill
8:05 pm
Press 1. 2, ENTER (0 not
necessary).
Numbers will “wink” to
indicate that the channel
has been set.
(TIMER SET)
10 30 pm CH. 12
8: 05 pm
The TIMER operates only once, but the time and the channel will
remain in the unit's memory.
If you want to preset the same channel at the same time for a
future date, press TIMER OFF/REPEAT. The TIMER lamp will light
up to indicate that the TIMER has been reactivated. If you want to deactivate the TIMER, press TIMER OFF/REPEAT
again so that the TIMER lamp goes out .
It is not necessary to summon “TIMER page” to use the TIMER
OFF/REPEAT button. Furthermore, this button is effective even if
the TV has been turned off.
To clear the TIMER setting, summon “TIMER page” and press
CLEAR,
To reset, clear the setting and follow the steps from step 3.
18