Sony CPD-220GS - Manual (Page 10)

Customizing Your Monitor
Using the GEOM (Geometry) On­
screen Display
The GEOM (geometry) settings allow you to adjust the
shape and orientation of the picture.
Once the rotation is adjusted, it will be storeddn memory for
all input signals received. All other adjustments will be
stored in memory for the current input signal.
1 Press the MENU button.
The MENU OSD appears.
2 Press the iii-4/^ and buttons to select
“ □ GEOM," and press the MENU button again.
The GEOMETRY OSD appears.
3 Press the buttons to select the item you want
to adjust.
Select To
O ROTATION adjust the picture rotation
n PINCUSHION adjust the picture sides
D PIN BALANCE adjust the picture side balance
O KEYSTONE adjust the picture width
KEY BALANCE adjust the picture shape balance
4 Press the 9^/"^ buttons to adjust the settings.
For Press
O ROTATION ... to rotate the picture clockwise
'E,
... to rotate the picture counterclockwise
O PINCUSHION “^ ... to expand the picture sides
*-0-*
... to contract the picture sides
D PIN BALANCE ^ ... to move the picture sides to the right
•
4
“
... to move the picture sides to the left
-a-
r\ KEYSTONE "4- ... to increase the picture width at the
top
^ ... to decrease the picture width at the
top
O KEY BALANCE
^ ... to move the top of the picture to
the right
to move the top of the picture to
the' left
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on.
The selected item is reset to the factory setting.
10