Sony CPD-220GS - Manual (Page 6)

etting Started
Setup
Before using this monitor, check that the following items are
included in your carton:
• Monitor (1)
• Power cord (1)
• Macintosh adapter (1) »
• Windows® Monitor Irdormation Disk (1)
» Warranty card (1)
• These operating instructiorrs (1)
• Audio nriniplug cord (1)
This monitor works with any IBM or compatible system
equipped with VGA or greater graphics capability.
Although this monitor works with other platforms running
at horizontal frequencies between 30 and 85 kHz including
Macintosh and Power Macintosh systems, a cable adapter is
required. Please consult your dealer for advice on which
adapter is suitable for your needs.
teli w
Connecting to an IBM PC/AT, Macintosh or
compatible computer
With the computer switched off, connect the video signal
cable to the computer's video output.
About the supplied Macintosh adapter
The supplied Macintosh adapter is compatible with Macintosh LC,
Performa, Quadra and Power Macintosh series computers.
Macintosh II series and some older versions of Power Book models
may need an adapter with micro switches (not supplied).
Note
Do not short the pins of the video signal cable.
With the monitor switched off, connect one end of the
power cord to the morutor and the other end to a power
outlet.
to a power outlet to AC IN
Power cord (supplied)
The installation of your monitor is complete.
Note
If "OUT OF SCAN RANGE" or "NO INPUT SIGNAL" appears on
the screen, see "Warning Messages" on page 18.
For customers using Windows* 95/98
Install the new model information from the "Windows* Monitor
Information Disk" into your PC.
Selecting the On-screen Display
Language
If you need to change the OSD language, see "Selecting the
on-screen display language" on page 15.
The default setting is English.