Sony CPD-220GS - Manual (Page 7)

Getting Started
Connecting Your Monitor's
Speaker
You can listen to music, sounds, and other audio files using
the speaker in your monitor.
Connect the AUDIO IN jack to the audio out jack of your
computer's sound card using the miniplug cord (supplied).
3 Press the buttons to adjust the volume.
1 Press the MENU button.
The MENU OSD appears.
The OSD automatically disappears after about 30 seconds.
To close the OSD, press the MENU button again.
To reset, press the RESET button while the OSD is on.
Press the MUTING button.
No sound comes from the speaker.
The ii8( mark appears at the bottom of the screen.
MUTING
To cancel, press the MUTING button again.
I
°
I
COLOR
I ce ^ er IL ™
J
SCREEN
n-
GEOM
SS
ZOOM
<3
SOONQ
B
SIZE
a
OPTION
2 Press the and buttons to select
"<l SOUND," and press the MENU button again.
The SOUND OSD appears.
You can listen to the audio signals from your computer
using headphones (not supplied). The speaker turns off
when headphones are connected to the headphones jack.
Adjust the volume using the SOUND OSD.
Note
If the volume from the speaker was too low, you can adjust the
input level (average of 500 mv) by the computer.
D 26 D
Note
While muting the sound, the mark appears in the SOUND OSD
instead of the ^ mark. Increase the volume to cancel the ijX mark
and activate the speaker.
7