Sony SLV-688HF - Manual (Page 7)

Step 3
■
Hookups
Selecting the best hookup option
There are many ways in which your VCR can be hooked up. To hook up
your VCR so that it works best for you, first scan through the table below.
Then use the accompanying diagramihand procedures on the following
pages to set up your VCR. For hookup 1 or 5, use the Sony RM-CMIOI
Cable Mouse (cable box controller) (not supplied).
If you have Use Refer to
TV that has audio/video inputs Audio/video (A/V) hookup, then
follow one of the hookups below.
Pages 8 and 9
Cable box that is compatible with the
VCR's cable box control feature Hookup 1 Pages 10 to 12
No cable box or incompatible cable box
with only a few scrambled channels Hookup 2 Pages 13 to 15
Antenna only, no cable TV Hookup 3 Pages 16 to 18
Incompatible cable box with many
scrambled channels Hookup 4 Pages 19 to 21
DSS'"’ receiver Hookup 5 Pages 22 and 23
Incompatible cable box with only a few
scrambled channels, using an A/B
switch Hookup 6 Pages 24 to 27
After you've completed the connections, follow the instructions for setup.
During setup, if you need more details on the procedure described, page
numbers are provided where you can find complete, step-by-step
instructions.
After you've completed the setup, you're ready to use your VCR.
Procedures differ depending on the hookup you used. For an overview,
refer to "Quick reference to using the VCR" on the back cover.
Before you get started
• Turn off the power to all equipment.
• Do not connect the AC power cords until all of the connections are
completed.
• Be sure you make connections firmly. Loose connections may cause
picture distortion.
• If your TV doesn't match any of the examples provided, see your nearest
Sony dealer or qualified technician.
DSS is a registered trademark of DIRECTV, Inc., a unit of Hughes Electronics Corporation.
Getting Started 7