Attaching the external antenna connector, Attaching a uhfa/hf band mixer – Sony SLV-688HF User Manual
Page 70
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Attaching the external
antenna connector
when using a 300-ohm twin lead cable
for a VHP / UHF antenna, use the EAC-
32 antenna connector (not supplied) to
connect the antenna to the VCR.
General setup information (continued)
300-ohm twin
lead cable
EAC-32 Antenna
connector (not
supplied)
1
Loosen the screws on the antenna connector.
Z Wind the twin leads around the screws on the antenna connector.
3
Retighten the screws.
Attaching a UHFA/HF band
mixer
when using both a 75-ohm coaxial cable
and a 300-ohm twin lead cable for a
VHP / UHP anfenna, use fhe EAC-66
UHP/VHP band separator/mixer (not
supplied) to connect the antenna to the
VCR.
300-ohm twin
lead cable
EAC-66
UHF/VHF
band
separator/
mixer (not
supplied)
75-ohm coaxial
cable
1
Loosen the screws on the mixer.
Z
Wind the twin leads around the screws on the mixer.
3
Retighten the screws.
4
Connect the 75-ohm coaxial cable to the mixer.
70 Additional Information