Installing the lithium battery, Put the lithium battery holder into the camcorder, Lithium battery life – Sony CCD-FX410 User Manual
Page 13: To change the lithium battery
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installing the Lithium Battery
To keep birth dates in the camcorder's memory as well as to activate the ciock, lithium
battery must be installed.
1
Remove the lithium battery holder
located at the bottom of the
camcorder.
Install the supplied CR2025
lithium battery with the + side
facing down.
Put the lithium battery holder into the camcorder.
Lithium battery life
The battery will last for approximately 1 year in normal operation.
When the lithium battery becomes weak, the indicator will blink in the viewfinder
screen for about 5 seconds when you set POWER to CAMERA, in this case, replace the
battery with a Sony CR2025 or Duracell DL-2025. Use of any other battery may
present a risk of fire or explosion.
When replacing the lithium battery, keep the battery pack or other power source attached.
Otherwise, readjustments of the date, time and birth dates will be necessary.
To change the lithium battery
Remove the lithium battery holder from the camcorder, and pull out the lithium battery and
insert a new one.
Warning Battery may explode if mistreated. Do not recharge, disassembie or dispose of in fire.
Caution Keep the lithium battery out of the reach of children.
Should the battery be swallowed, consult a doctor immediately.
Getting Started "| 0