Chapterl :gettingstarted, Charging and installing the batt, Charging the battery pa – Sony CCD-FX410 User Manual
Page 6: Charging and installing the battery pack, Important
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Chapterl :GettingStarted
Charging and Installing the Batt
Before you can use this camcorder, you need to charge and install the battery pack.
Charging the Battery Pa
1 Plug the AC power adaptor into a wall outlet.
2 Align the flat side of the battery pack with the line on the AC power adaptor.
3 Push down and slide the battery pack in the direction of the arrow.
4 Set the CHARGE/VTR switch to CHARGE.
Required charging time:
Type of battery pack
NP-55H
(supplied)
NP-77H/
NP-77HD
NP-77
NP-66H
NP-55
Required charging time
70
140
120
100
60
(approx, minutes using AC-V60A)
When charging is finished, the charge indicator will go out.
Important!
Use the battery completely before charging!
Before you recharge the battery, make sure the battery has been used (discharged)
completely to avoid capacity down of the battery caused by excessive charging.
To use up the battery, remove the video cassette and simply slide POWER to CAMERA
with the battery attached, and leave the camcorder until the CXi indicator appears
blinking and a red lamp blinks in the viewfinder.
0 Getting Started