Sony SLV-373UC - Manual (Page 19)

How to attach the external antenna connector (supplied)
^ Loosen the screws on the antenna connector.
p Fit the 300-ohm twin iead <
^ screws on antenna connec
3 Tighten the screws again.
p Fit the 300-ohm twin iead cabie on the UHF antenna under the
^ screws on antenna connector.
- 300-ohm twin
lead cable
How to attach the EAC-66 U/V band separator/mixer (not supplied)
^ Loosen the screws on the U/V band separator/mixer.
2
3
Fit the 300-ohm twin iead cable on the UHF antenna under the
screws.
Connect the 75-ohm coaxial cable to the U/V band
separator/mixer.
A Connect the U/V band separator/mixer to the VHF/UHF IN on the
^ VCR.
the RF Unit
Why this setting is necessary
Your TV receiver must be set to receive the signal from
your VCR. To get the proper RF signal, set the RF UNIT
selector switch on the rear panel ot the VCR. If channel
4 Is active in your area, set the switch to 3 CH, and vice
versa. If you connect a color monitor or a TV
equipped with video/audio input jacks, you do not
need to make this adjustment.
1
2
3
4
Set the RF UNIT at the rear to 3 CH or 4 CH,
whichever is not active in your area.
Press POWER.
The indicator will light.
Press ANT TV/VTR so that the VTR indicator
lights.
Check that the TUNER indicator appears in the
display window, then select an active channel in
your area by pressing CHANNEL + I - .
Turn on the TV and set the TV to the channel
selected in step 1.
The TV program selected on the VCR will appear on
the
screen.
Your TV is now tuned to the VCR. Whenever you use the
VCR, set the TV to the channel selected above.
Note
For details about TV channel adjustment, see the instruction manual of the TV.
19