Sony KV-27XBR65 - Manual (Page 48)

Using the Programmable Remote Commander
For your convenience
We have provided a label with a summary of instructions
on how to use the Remote Commander which you can
stick on the back of the Remote Commander.
When replacing the batteries, do it within approximately
30 minutes. Otherwise, the memorized functions may be
erased.
• The Remote Commander beeps repeatedly if there is
inappropriate operation. Try again from Step 4.
• Be sure to confirm that the functions have been
memorized as a few commanders of other
manufacturers are not storable on this Remote
Commander.
• Do not use the learning function for equipment other
than video and audio.
• When operating equipment with learned functions, the
selectors should be set to the same position as they
were when the functions were memorized.
• When a new function is assigned to a button, the
previous function is cleared automaticaJIy.
• When the merrraries are full, the LEARN indicator
lights steadily if you try to memorize a new function.
In such a case, set the USE/LEARN selector to USE to
turn the indicator off, then clear the unnecessary
functions (see page 49).
The learning function will not work in the following
cases:
• There is a fluorescent lamp or equipment which emits
infrared energy.
-► Move the Remote Commanders away from such
infrared sources.
• The batteries are exhausted.
Replace all the batteries with new ones.
• There is an obstacle between the Remote
Commanders, or the Remote Commanders are not
positioned head to head and exactly aligned.
-*• Position the Remote Commanders properly.
48