Sony PCV-E205 - Manual (Page 3)

Regulatory Information
Declaration of Confonnity
Trade Name; SONY
Model No.: PCV-E20I, PCV-E203,
PCV-E205
Responsible Party:
Sony Electronics Inc.
Address:
1 Sony Drive
Park Ridge, NJ 07656
Telephone No: 201-930-6970
This device compiles with Part 15 of
the FCC rules. Operation is subject
to the two following conditions: (1)
This device may not cause harmful
Interference, and (2) this device
must accept any interference
received, including interference that
may cause undeslred operation.
This equipment has been tested and found
to comply with the limits for a Class B
digital device, pursuant to Part 15 of the
FCC rules. These limits are designed to
provide reasonable protection against
harmful Interference in a residential
installation. This equipment generates,
uses, and can radiate radio frequency
energy and,-if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guartmtee that Interference will not occur
in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the Interference by one or more of
the following measures:
□ Reorient or relocate the receiving
antenna.
□ Increase the separation between the
equipment and the receiver.
□ Connect the equipment into an outlet
, on a circuit different from that to
which the receiver is connected.
□ Consult the dealer or an experienced
radlo/TV technician for help.
You are cautioned that any changes or
modifications not expressly approved in
this manual could void your authority to
operate this equipment.
Only peripherals (computer input/output
devices, terminals, printers, etc.) that
comply with FCC Class B limits may be
attached to this computer product.
Operation with non-compliant peripherals
is likely to result in Interference to radio
and television reception.
All cables used to connect peripherals must
be shielded and grounded. Operation with
cables, connected to peripherals, that are
not shielded and grounded, may result in
interference to radio and television
reception.