Using alternate power sources, Using house current – Sony CCD-TR61 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
[Advanced Operations!
Using Alternate Power Sources
You can choose any ot the following power sources for your camcorder battery pack (p. 7), house
current and 12/24 V car battery. Choose the appropriate power source depending on where you want to
use your camcorder.
Place
Power source
Accessory to be used
Indoors
House current
AC power adaptor AC-V25A/2SA (supplied). AC-S10,
AC-V55
Outdoors
Battery pack
Battery pack NP-SS (supplied), NP-77HD, NP-77H,
NP-77, NP-66H, NP-S5H
In the car
12 V or 24 V car battery
DC pack DCP-77
Using House Current
To use the supplied AC-V25/V25A AC power adaptor: (1) Lift up the viewfinder. (2) Connect the AC power
cord to a wall outlet The POWER lamp (green) lights up. Connect the bottom of the AC power adaptor to
the batter>* mounting surface of the camcorder. (3) Set the selector to VIR (OC OUT).
1
I
I
00
s
I*
o
Note on the POWER lamp
e The POWER lamp will remain lit for a while even if the unit is unplugged after use. This is normal.
• If the POWER lamp does not light, set the selector to OFF and disconnect the power cord. After about
one minute, reconnect the power cord and set the selector to VTR (DC OUT) again.
To remove the adaptor
The adaptor is removed in the same way as the battery pack. (p. 7)