Trouble check, Camcorder – Sony CCD-TR61 User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Trouble Check
If you run into any problem using the camcorder, use the following table to troubleshoot the problem
Should the difficulty persist, disconnect the power source and contact your Sony dealer or local
authorized Sony service facility.
Camcorder
Symptom
Cause
Corrective Actions
page
The power is not on.
The battery is not
attached.
Attach the battery.
7
The battery is dead.
Use a charged battery.
6
The AC power adaptor is
not connected to a wali
outlet.
Connect the AC power adaptor to
a wail outlet.
25
1
The power goes off.
While being operated in
CAMERA mode, the
camcorder has been in
the Standby mode for
more than 5 minutes.
Turn the STANDBY switch to
LOCK once and turn it to
STANDBY again.
16
The battery is dead.
Use a charged battery.
6
The battery pack is
quickiy discharged.
The ambient
temperature is too low.
—
8
The battery pack has not
been charged fully.
Charge the battery pack again.
6
The battery pack is
completely dead, and
cannot be recharged.
Use another battery pack.
9
START/STOP does not
operate.
The tape is stuck to the
drum.
Eject the tape.
13
The tape has run out.
Rewind the tape or use a new
one.
23
The POWER switch is
set to PLAYER.
Set it to CAMERA.
16
The tab on the cassette
is out (red).
Use a new tape or slide the tab.
17
The cassette cannot be
removed from the
holder.
The battery is dead.
Use a charged battery or the AC
power adaptor.
6. 25
1
No function except for
cassette ejection works.
Moisture condensation
has occurred.
Remove the cassette and leave
the camcorder for at least an
hour.
36
o
The tape does not move
when a tape transport
button is pressed.
The POWER switch is
set to CAMERA or OFF.
Set it to PLAYER
23
The tape has run out.
Rewind the tape or use a new
one.
23
The autofocusing
function does not work.
Shooting conditions are
not suitable for
autofocusing operation.
Adjust the focus manually.
27
The power zoom button
does not work.
WIDE ANGLE is working.
This is not the malfunction.
Siide the WiDE ANGLE switch in
the opposite direction of the
arrow.
19