Sony SLV-750HF - Manual (Page 24)

Activating the Cable Box Control Function
Cable box code number chart
In step 4 on page 23, enter the code number of your cable
box as listed in the chart below.
Brand IR Code No.
Hamlin 14.15
Jerrold/
General Instrument
1,2, 3.4
Oak 17, 18
Panasonic 12,13
Philips 22
Pioneer 8,9
Regal 14,15
Regency 20
Scientific Atlanta 5.6
Tocom 10.11
Zenith 7
Checking the Cable Box Control Setting
Using the information provided below, check to make sure
that you have made the correct Cable Box Control setting.
Note
Make sure to do the following when using a cable box.
• Tap the buttons lightly. Do not hold the buttons down.
• Position the cable box away from the VCR. Do not point
the Remote Commander at the cable box. Point it at the
VCR.
1 Press CH +/- on the Remote Commander.
Does the channel indicator on the cable box change?
2 Press all 10 channel number buttons on the Remote
Commander (0 to 9). Does the channel indicator on the
cable box change?
If the answer to both 1 and 2 is ‘Ves.* you have made the
correct setting.
If you cannot get your VCR to control the cable box
Try the setup again making sure to use the correct code
number.
If, after checking your setup, you are sure that the VCR will
not control your cable box. contact your cable company.
They may be able to supply a compatible cable box.
The VCR contains 42 cable box codes (1-42). If your cable
box is not listed in the chart, it may be possible to control it
using one of the other (1 -42) codes. You may want to try
other codes before calling your cable company to see if they
can supply a cable box that is in the chart.
If your cable box is listed in the chart, but does not respond,
first check the placement of the Cable Mouse (see page 22),
and try placing the cable box and VCR away from each other
(do not place the cable box directly on top of the VCR). If the
cable box still does not respond, you can try other codes.
24 Preparation