Sony SLV-750HF - Manual (Page 54)

Editing
Editing onto Another VCR
Here's how to use this VCR as the playback VCR and
another VCR as the recording VCR.
INPUT SELECT: Select external video or line
Other settings: Set for recording
Before you start:
• Select the EDIT position on the PICTURE switch.
If your recording VCR has an editing function, it should
also be selected to improve reception.
• Press DISPLAY to TURN OFF the display.
How to edit:
1 Turn on the recording VCR and insert a blank
cassette with a safety tab In place.
2 Insert a source cassette into the playback VCR.
3 Locate the playback start point and select the
playback pause mode on the playback VCR.
4 Locate the recording start point and select the
recording pause mode on the recording VCR.
5 Press II PAUSE on both VCRs.
For best results, press II PAUSE on the playback VCR
just before pressing II PAUSE on the recording VCR.
When you’ve finished editing, press ■ STOP on both
VCRs.
NOTES:
• If your recording VCR is a stereo unit, make
connections with the supplied audio/video connecting
cable.
• If your recording VCR is a monaural unit, make
connections using the VMC-910MS/920MS cable
(not supplied).
• When connecting the VCRs, do not connect both
LINE IN and LINE OUT jacks on your VCRs
simultaneously. Doing so may cause a humming
noise.
• Tapes recorded using the APC function are played
back normally on VCRs that do not have the APC
function.
• If you have the PICTURE switch on the VCR set to
EDIT, the APC function does not operate when
playing back a tape but does operate when recording.
When you are editing tapes (dubbing) using this unit
as either the recording VCR or the playback VCR.
use the EDIT setting.
54 I
Advanced Operations