Craftsman 113.248510 - Manual (Page 13)

5. Use truss head bolts, lockwashers, and hex nuts to
mount the two (2) rear legs to the basic saw assem­
bly. It may be necessary to slightly tilt the saw as­
sembly backwards in orderto get thefour (4) holes in
each corner of the saw to line up with the four (4)
holes in the top of each leg. Finger tighten nuts at
this time.
6. Attachthefour(4)/owe/'si/ffene/'stothe/egs.Two(2)
truss head bolts, washers, and hex nuts are re­
quired to hold each end oi a lower stiffener\n place.
Only hand tighten hex nuts.
7. Go back with a Vis wrench or socket and tighten all
hex nuts.
8. Carefully lift the saw into its normal position. It may
be necessary to have someone help you in order to
avoid damaging the saw.
ADJUSTING LEVELING FEET
WARNINGS TO AVOlO INJPORY FROM UNEX­
PECTED SAW OR WORK MOVEMENT, LEVEL­
ING FEET MUST BE ADJUSTED SO THAT SAW
DOES NOT ROCK.
To adjust leveling feet so the saw will sit properly;
a. Move saw to desired location.
b. Raise or lower leveling foot by turning it clockwise or
counterclockwise.
c. Tighten nuts to lock leveling foot in place.
MODEL 113.248510
ASSEMBLING CABINET
1. Separate all “loose” parts from packing materials
and check each item with “Parts List" to make
sure all items are accounted for before discard­
ing any packing material.
From loose parts find the following items:
ITEM DESCRIPTION QTY.
1 Right Side Panel............................................ 1
2 Left Side Panel ............................................. 1
3 Lower Shelf.................................................... 1
4 Skirt................................................................ 2
5 Shelf Stiffener................................................ 1
6 Corner Bracket .............................................. 2
7 Spacer............................................................ 2
8 Door............................................................... 1
Bag of Loose Parts #508166
Containing Following Items:
Screw, Truss Hd. 1/4-20x1/2.............................. 34
Lockwasher.Ext. 1/4............................................34
Nut, Hex 1/4-20...................................................34
Foot, Leveling 3/8................................................. 4
Nut, Hex Jam 3/8-16.............................................8
Bag of Loose Parts #507530
(In Cabinet Assembly)
Containing Following Items:
Screw, Pan Hd. #6-10x1/2................................... 2
Screw, Pan Hd. Ty “T” 6-32 x 3/8........................ 2
Screw, Pan Hd. #10-10x1/2................................. 4
Catch Magnetic....................................................1
Hinge Door........................................................... 2
13