Craftsman 113.248510 - Manual (Page 5)

f. To avoid being suddenly caught in the blade:
1. Do not wear gloves.
2. Remove all jewelry and loose clothing,
3. Tie back long hair.
4. Roil long sleeves above the elbow.
g. Toavoid injury from accidental starting, always
unplug saw, turn switch off and remove switch
key before removing the guard, installing or
removing any blade, accessory or attachment,
or making any adjustments.
h. To avoid slips and jams causing injury;
1. Choose the right size and style blade for the
material and the type of cutting you plan to
do. Use this band saw to cut and sand only
wood, wood like products and plastic.
2. Make sure the blade teeth point downward
toward the table.
3. Make sure the blade tracking guides and
thrust bearings are properly adjusted.
4. Always check and correctly adjust biade or
sanding belt tension.
i. To avoid accidental blade contact, minimize
blade breakage and provide maximum blade
support.
1. Always adjust the upper blade guide and
blade guard to just clear the workpiece.
2. Plan your hand placement so your fingers
will not be where a sudden slip could cause
them to hit the blade.
j. Make sure all clamps and locks are tight and
there is no excessive play in any parts.
k- To avoid an electrical shock, make sure your
fingers do not touch the metal prongs on the
plug when installing or removing theplugtoor
from a live outlet.
i. Never turn your band saw “ON” before clearing
everything except the workpiece and related
feed or support devices off the table.
BEFORE SANDING
1. Keep the table and sanding belt adjusted so the
gap between them is no more than 1/16-inch
wide,
2, To avoid fire, shock, or cause electrical shorts,
do not sand metal. It could ignite the sawdust
inside the saw.
WHENEVER SAW IS RUNNING
WARNING; DO NOT ALLOW FAMILIARITY
(GAINED FROM FREQUENT USE OF YOUR
BAND SAW) TO CAUSE A CARELESS MIS­
TAKE. ALWAYS REMEMBER THAT A CARE­
LESS FRACTION OF A SECOND IS SUFFI­
CIENT TO INFLICT SEVERE INJURY.
a. If your saw makes an unfamiliar noise or if it
vibrates excessively, stop immediately. Turn
the saw off. Remove switch key and unplug
the saw. Do not restart until finding and
correcting the problem.
b. Avoid awkward hand positions where a sudden
slip could cause a hand to move into the blade
or the sanding belt.
c. Feed the workpiece only fast enough to letthe
blade cut without bogging down or binding.
d. Before freeing jammed materia!, turn saw off.
Remove switch key. Remove plug from power
source outlet. Wait for all moving parts to stop.
e. When backing up the workpiece, the blade
may bind in the kerf (cut). This is usually
caused by sawdust clogging up the kerf or
because the blade comes out of the guides. If
this happens:
1. Turn saw off.
2. Unplug saw.
3. Remove switch key.
4. Wait for all moving parts to stop.
5. Remove band saw cover.
6. Stick a fiat blade screwdriver or wedge into
the kerf.
7. Turn the upper wheel by hand while backing
up the workpiece.
f. Before removing loose pieces from the table,
turn saw off and wait for ail moving parts to
stop.
ACCESSORIES
USE ONLY RECOMMENDED ACCESSORIES. Follow
the instructions that come with the accessories. Con-
sullthe owner’s manual for recommended accessories.
The use of improper accessories may cause risk of
injury to persons.