Craftsman 113.248510 User Manual
Page 31
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
3. Locate the two (2) oval point setscrews 1/4-20 x
1/2 and use an 1/8-inch hex “L” wrench to install
in the two holes, as illustrated, but do not allow
the screws to extend beyond the underside of the
table.
4. Locatethetwo(2)tablelatches,two(2)3/a"longPhil-
lips head self tapping screws, two (2) small washers,
and one (1) large washer.
5. Place front table latch through slot on right side of
bandsaw frame.
6. Tilt top of front table latch si ightly forward and place
targe washer between bracket and bandsaw frame.
7. Place self tapping screw through small washer and
attach to table latch. Do not completely tighten
screw.
8. Attach left side table latch with self tapping screw
and washer as shown.
ASSEMBLE WITH LATCH TO
HIGHEST ADJUSTING POSITION
9. Locate the table alignment key and the two (2)
V4-20 X1 low head capscrews. Install the key under
the rear table miter gage slot and install the two
screws but do not tighten at this time.
3T